• Stonelight products work with 12 V DC Voltage. They should never be operated under alternative voltage.
• Stonelight products are being connected to each other and parallel to the circuit (Diagram 1). Otherwise our products are not going to operate.
• Only suggested transformers should be used for feeding the circuit and they should be at calculated power.
• Usage and warranty periods of the transformers should be taken intoconsideration and their periodical controls should be performed during those periods. Adapters and transformers should be installed in panels and away from natural facts and environmental conditions such as moisture, dust, water, etc. to avoid negative affects.
• The longest circuit length suggested for Stonelight products is 100 meters.
• The cable should be (2x1,5 mm) flexible multi-wired YVV under ground cable as suggested by the company The underground cables are being manufactured specially by our company’s order.

Maintenance and Cleaning

The cleaning of the outer surface which gets dirty by time can be performed by a steel brush and clean water. No surface corrosion occurs. The black dirt caused by exhaust gas and oil on the surface caused by traffic area usage can be cleaned by cellulosic thinner. No corrosion occurs as a result of that cleaning.

Installation Instructions

1. Blue cables are positive (+) poles and Brown cables are negative (-) poles on all Stonelight products.
2. The joints between the product and the main line are soldered.
3. The joints are being installed and locked in special conduit boxes after insulated by being wrapped by an insulation band.
4. Insulation is being provided by filling the conduit box with silicone through the holes. (excess silicone should leak from the joints of conduit box)

T-Type Conduit Box Connection Photos

E-Type Conduit Box Connection Photos

Installation Instructions for RGB Products

1. Common end is black cable, R is red cable, G is green cable and B is blue cable on all Stonelight RGB products.
2. The joints between the product and the main line are soldered.(Diagram 3)
3. The joints are being installed and locked in special conduit boxes after insulated by being wrapped by an insulation band.
4. Insulation is being provided by filling the conduit box with silicone through the holes. (excess silicone should leak from the joints of conduit box)
5. Transformer outlet is being connected to 12 V Raindow Card (Diagram 5.) Rainbow Card Outlet constitutes the main line.