• Stonelight products operate with the voltage of DC12V - DC24V. They should never be operated under alternative current.
• Stonelight products get parallel connected (Figure 1) to each other and to the circuit. Otherwise our products doesn’t
  work.
• Transformer to feed the circuit should be on suggested and/or calculated power.
• Transformers should be controlled on a reasonable schedule depending on their lives and guarantee periods. The products
  operates with DC12V - DC24V and that’s why adapters and transformers should be kept away from negative natural
  conditions and environmental facts (humidity, dust, water, etc.) and they should be placed in a panel.
• Maximum suggested circuit length for Stonelight products is 75 meters. (for 1,5 mm cross-section cables)
• Our company suggests (2x1,5 / 4x1,5) YVV underground cables. Under ground cables are manufactured upon our special
  order.

Maintenance and Cleaning

The cleaning of the outer surface which gets dirty by time can be performed by a steel brush and clean water. No surface corrosion occurs. The black dirt caused by exhaust gas and oil on the surface caused by traffic area usage can be cleaned by cellulosic thinner. No corrosion occurs as a result of that cleaning.

Mounting Instructions for Single Colour Products

1. The blue cable is the (+) pole and the Brown cable is the (-) pole on all Stonelight products.
2. The connections between the product and the main line should be soldered.
3. Connections get placed in a special junction box and get locked after isolated by an electric tape.
4. Isolation is maintained by injecting silicone into the junction box through the hole. (Silicone should get out from the
   joints of the junction box.)

Connection Pictures

Mounting Instructions for RGB Products

1. Black cable is the common lead, R is the red lead, G is the green lead and B is the blue lead on all Stonelight RGB products.
2. The connections between the product and the main line should be soldered. (Diagram 3)
3. Connections get placed in a special junction box and get locked after isolated by an electric tape.
4. Isolation is maintained by injecting silicone into the junction box through the hole. (Silicone should get out from the
   joints of the junction box.)
5. Transformer output gets connected to DC 12V Smaster Card. (Figure 4) Smaster Card constitutes the main line.